Measurements & Derived Quantities

The dimensions Estimatics derives from a LiDAR scan — floor area, perimeter, ceiling height, paintable area, and element counts — and how Assign geometry feeds them into your estimate.

4 min read


Once a room is scanned, Estimatics derives the dimensions you need to scope. You don't re-key numbers from a tape measure or a photo.


What gets derived

For each scanned room, you get:

  • Floor area — in square feet
  • Perimeter — in feet
  • Ceiling height — in feet
  • Paintable area — in square feet
  • Element counts — walls, doors, windows and openings detected in the space

On the web, these show in the summary card on the Geometry tab's FLOOR PLAN view: Floor area, Paintable area, Ceiling height, Perimeter, Walls and Doors / Windows. Choose All Rooms or pick rooms to see their totals, grouped by floor ("Ground Floor", "2nd Floor"). On iPhone, the floor plan shows the same measurements, and ELEVATIONS lists each wall with its Length, Height and Net area.

These come from the interior LiDAR scan. Estimatics doesn't measure roofs, and exterior geometry is coming soon, so there are no derived roof or exterior quantities today.

ℹ Note

On iPhone, the floor-plan image shows surfaces in square feet and height in meters, so the units on that image look mixed. It is a known display quirk.


Measuring inside the scan

You can take your own measurements without leaving the app:

  • 3D MODEL (web and iPhone): choose Measure, then pick the two points you want to measure between. On iPhone, the tool snaps to corners.
  • Photos taken during a LiDAR scan (iPhone): these carry depth data, so the Measure tool in photo markup can place a dimension on the photo, shown in centimeters or meters.

See Floor plans and 3D models and Photo markup.


How they feed the estimate

The numbers reach the estimate through Analyze, one area at a time:

  1. In Analyze, open an area. Its card says Measured or Declared. A declared area was named by the inspector and has no scan behind it; its dossier says "Declared — no scan yet". If no scan is linked, the card warns "No geometry linked", or "No dimensions — estimate stays at $0" when the area has no floor area yet.
  2. Click Assign on the area card, or Assign measures in the area dossier. (When Estimatics finds a suggested match, the Review button on the banner above the areas does the same.) The Assign geometry window opens.
  3. Pick the scanned room. The best matches are marked Suggested, with their square footage.
  4. Click Link measures. To undo it, click Unlink.

When you link or unlink, the estimate lines for that area recalculate on their own. You'll see "Measures linked — N estimate lines requantified." Floor area drives flooring, paintable area drives paint, perimeter drives baseboard. On iPhone, the same step is Assign measures in Analyze → AREAS.

Super Admin, Estimator and Field Inspector can assign geometry. If an area already shows "Measured by its own scan", it is linked and doesn't need assigning. If the window says "No measured scan rooms yet", scan the property with the iPhone app first. See Areas and approval.


"Measured" vs. not

Derived quantities appear only for scanned rooms. An area that hasn't been scanned or linked doesn't carry dimensions. That is a useful signal that it still needs geometry before you scope it.

Trust, but verify

Derived quantities are strong inputs, not final answers. Scan quality, obstructions, and complex geometry can affect them, and Estimatics doesn't give a scan quality score. Check the numbers against the space, especially on high-value line items, before you rely on them in the estimate. The measurement supports your judgment. It doesn't replace it.



Last updated: October 2026 · Questions? Email support@aiestimatics.com

Last updated: October 2026 · Feedback on this article